HAMILTON & DISTRICT BUDGERIGAR SOCIETY INC.

Standard W.B.O. Show Cage SPECIFICATIONS & Drawings


Show Cage

Size

Overall measurements 355mm long 305mm high 165mm wide

Bottom

355mm long 162mm wide 6mm thick

Sides

293mm high 162mm wide 9mm thick with 25mm radius in top front corner

Top

355mm long 140mm wide 6mm thick with 85mm 30mm kidney shaped hand hole positioned centrally in length and 40mm from rear

Back

355mm long 230mm high 3mm thick

Sloping roof

9mm thick positioned 220mm from bottom of cage and 45mm from front of cage. Centre of junction between top of cage and sloping roof to be stiffened by triangular block of wood.

Front rail

70mm high from floor of cage x 9mm thick

Door size

100mm high 90mm wide externally with sloping bevel cut to top, bottom and left hand edges

Right hand edge

To be straight cut

Bottom of door

To be 95mm from bottom of cage and centred on side panel

Door corners

On the opposite side to the hinges can be radiused up to 5mm

Door fasteners

One plain brass desk turn 25mm long fixed by brass screw to side of cage to coincide with a raised head brass screw positioned 12mm in from front left hand edge of door and 50mm from top of the door. One plain brass desk turn 25mm long fixed above top left side of door to line up with side fixing set 12mm in from edge of door

Door hinges

Two strong hinges 25mm 16mm fixed on right hand side of door and 10mm from top and bottom of door

Door pull

25mm 16 gauge wire black painted S hook in centre of door

Perch size

14mm diameter with both ends cut flush

Perch position

Centre of perches and screw holes to be 140mm (external) from bottom of cage and 112mm apart.

Perch fixings

Perches to be secured to back of cage with counter sunk screws and brass cup washers and to centre crossbar on wire front of cage by 3mm deep horizontal saw cut

Wire front

Comprises of 21 14 gauge unpainted stainless steel bars at 16mm centres with 20mm radius at top and welded to 10 gauge bottom, middle and two top crossbars

Middle bar

To be on outside of cage

Centre of middle crossbar

To be 140mm above bottom of cage

Front

To be fixed to cage by three extended wires at bottom and top

Centre wire

at the top of the cage to be cut to avoid excessive protrusion

Drinker

White plastic finger drawer type not to exceed 50mm in overall length.The drinker be placed between the 4th and 5th wire from the left and resting on the middle bar at all times

Colours

White matt inside. Black gloss outside including top of front rail

 Cages produced in alternative materials must comply with all internal and external dimensions
and give a similar appearance to a wooden cage when viewed from the front. Note: Sizes in millimeter (mm)

 

Cage Drawing

WBO Cage Drawing

Door Sample

WBO Door sample



EMAIL

E-Mail: berniehansen@sympatico.ca

[ GO BACK ]

GO [HOME]

- TOP -


H&D Budgerigar Society Inc.