COAX ......50 OHM
( PL-259) TYPE DE CABLE RG-8/U, 9/U, 11/U, 63/U, 87A/U, 213/U, 214/U, 225/U
Slide coupling ring onto cable. Cut end of cable even and strip jacket, braid and dielectric to dimensions shown in table. All cuts are to be sharp and square. Do not nick braid, dielectric or center conductor. Tin exposed center conductor and braid, avoiding excessive heat.
Screw the plug sub-assembly on cable. Solder assembly to braid through solder holes making a good bond between braid and shell. Solder conductor to contact. Do not use excessive heat.
For final assembly on straight plugs, move coupling ring forward and screw in place on plug sub-assembly.
------------------------------------------------------------------------------------
MINI UHF CRIMP CONNECOR ( 3PIESE CONSTRUCTION )
TYPE DE CABLE RG-58/U, 59/U, 62/U, 213/U, 225/U
Trim cable as shown, being careful not to nick the inner conductor or braid.
Slip crimp sleeve over cable. Place inner conductor into contact. Note that the end of contact and inner dielectric must be butting and square. Crimp with appropriate tool
Flair outer braid and gently but firmly push the contact into the connector housing until a gentle snap is felt, indicating the contact is in place. Slip the crimp sleeve in place, butting the flange against the connector body and crimp with appropriate tool.
-----------------------------------------------------------------------------------------------------------------------------